SFP+-transceiver CBO SFP-10G-ER-1310 10G 1310 nm

The SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310 nm is a hot-pluggable optical module designed to provide 10 Gigabit connectivity over single-mode fiber using a 1310 nm wavelength. It fits standard SFP+ ports and is intended for long-reach Ethernet and optical network links where 10G throughput and reliable signal integrity are required. The module supports straightforward insertion into switches, routers and servers equipped with compatible SFP+ slots and enables high-speed data transmission for backbone and aggregation connections.

Advantages

This SFP+ transceiver delivers 10 Gbps performance with long-reach capability at 1310 nm, enabling extended fiber links while maintaining low power consumption and compact SFP+ form factor. The hot-pluggable design allows replacement or installation without powering down equipment, and compatibility with standard SFP+ interfaces simplifies integration into existing network infrastructures. The optical interface ensures stable signal quality for demanding data-center and carrier Ethernet environments.

Suitable for

• Long-reach 10 Gigabit Ethernet links between switches and routers
• Server uplinks and aggregation ports in data centers
• Metropolitan and carrier optical networks requiring 1310 nm transmission
• Fiber backbone connections where single-mode fiber is deployed

Key specifications

• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Form factor: SFP+
• Fiber type: single-mode fiber (SMF)
• Transmission range: designed for long-reach optical links
• Interface: duplex LC optical connector
• Hot-pluggable: yes
• Typical power consumption: low (SFP+ class)

How to use

Install the transceiver by inserting it into an empty SFP+ slot on a compatible switch, router or server until it seats securely. Connect single-mode fiber with a duplex LC connector to the module, observing proper transmit/receive orientation. After installation, verify link status through the host device management interface and confirm 10 Gbps operation and signal integrity. To remove the module, power down the port if required by your equipment policies or use the device's hot-swap procedure, then gently pull the transceiver from the slot.

Recommendations

Use clean fiber connectors and certified single-mode patch cords to maintain optimal optical performance. Verify compatibility with the host device's SFP+ slot and firmware, and follow manufacturer guidelines for handling electrostatic-sensitive components. For long-distance installations, check link budget and attenuation to ensure the 1310 nm transceiver meets the required reach and signal margin.