SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm module

The BlueOptics SFP+ Transceiver CBO SFP-10G-ER-1310 10G 1310nm module is a compact hot-pluggable optical interface designed for 10 Gigabit Ethernet. Operating at a 1310 nm wavelength for single-mode fiber, this SFP+ transceiver is intended for long-reach fiber links and offers straightforward installation into compatible 10G network equipment. The module supports standard 10G Ethernet connections and provides a stable physical layer solution for data center uplinks, campus backbones, and service provider networks.

Advantages

The SFP+ transceiver delivers 10 Gbps throughput while maintaining a small form factor and hot-swap capability, reducing downtime during maintenance. Its 1310 nm single-mode design enables extended reach over single-mode fiber, making it suitable for long-distance links. The module follows standard SFP+ electrical and optical interfaces for broad compatibility with network switches, routers and optical equipment that accept SFP+ form-factor transceivers.

Suitable for

• Long-reach 10 Gigabit Ethernet links over single-mode fiber
• Data center uplinks and spine-to-leaf connections
• Campus and metro backbone links requiring 10G capacity
• Service provider aggregation and inter-site connectivity

Key specifications

• Data rate: 10 Gigabit Ethernet
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+ (hot-pluggable)
• Typical reach: designed for long-reach single-mode links
• Interface: duplex optical LC connector compatible

How to use

Install the transceiver into an SFP+ slot on compatible network equipment while the host device is powered according to the vendor guidelines. Connect single-mode fiber cables with LC duplex connectors to the optical ports, ensuring correct transmit/receive orientation. After physical insertion and fiber connection, verify link status and configure interface settings on the network device as required for 10 Gigabit Ethernet operation. Handle the module by the housing to avoid touching fiber endfaces and use dust caps when the ports are not connected.

Recommendations

Use single-mode fiber rated for 1310 nm and verify fiber continuity and connector cleanliness before deployment. Match the transceiver with network equipment that supports SFP+ modules and confirm firmware or compatibility lists if required. Maintain appropriate electrostatic discharge (ESD) precautions during handling and store unused modules in protective packaging to prevent contamination or damage.