SFP+ transceivermodule CBO AXSK‑SFP+ SR 10 Gbit/s 850 nm

CBO AXSK‑SFP+ SR is an SFP+ transceiver module designed for short‑range 10 Gbit/s optical links using an 850 nm wavelength. The module supports transmission over multimode fiber and fits hot‑pluggable SFP+ ports on compatible switches, servers and storage devices. It is intended for data center uplinks, server interconnects and SAN connections where compact, low‑latency 10 Gbit/s links are required.

Advantages

The transceiver delivers a standardized 10 Gbit/s data rate with an 850 nm VCSEL light source optimized for multimode fiber, allowing reliable short‑reach performance. Its hot‑pluggable SFP+ form factor enables straightforward installation and replacement without powering down equipment, simplifying maintenance and upgrades. The module is compatible with common network equipment that accepts SFP+ optics and is built to provide consistent optical link quality for dense networking environments.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ port until it clicks into place, observing proper orientation for the module and port. Connect duplex LC multimode fiber patch cords to the module—ensure the transmit and receive fibers are correctly crossed between devices. After insertion and fiber connection, verify link status via the host device interface and monitor optical and link indicators. For removal, power down interfaces if recommended by the equipment vendor or follow hot‑swap procedures, then depress the module latch and withdraw the transceiver carefully.

Recommendations

Use multimode fiber of appropriate grade (OM3/OM4) and quality patch cords to achieve expected short‑reach performance at 10 Gbit/s. Keep optical connectors clean and protected with dust caps when not in use. Verify compatibility with the target switch or host device and consult equipment documentation for any vendor compatibility settings or required firmware updates.