Bosch 2 608 833 798 boorhamerboor 1 st.

Hammer drill bit Bosch 2 608 833 798 with a 1 cm diameter is designed for use with rotary hammers that accept SDS plus shanks. The bit is intended for drilling in masonry and reinforced concrete and is supplied as a single piece. It features a centring tip and a specialised head geometry to ensure accurate hole diameters and reliable fixation of anchors.

Advantages

The SDS plus-5X design with a “turn-angle” head and a 4-flute body provides efficient dust evacuation, enabling faster drilling speeds and reduced wear. The centring tip guides the drill from the start, improving precision. The bit carries the PGM Masonry Drill Bit Association Board test mark, which certifies tight tolerances, accurate holes and a secure hold of fixings. Compatible with SDS plus rotary hammers.

Suitable for

• Drilling holes in reinforced concrete
• Creating anchor and fixing holes in masonry
• Heavy-duty drilling tasks with SDS plus rotary hammers

Key specifications

• Brand: Bosch
• Manufacturer part number (MPN): 2608833798
• EAN: 6949509223517
• Shank type: SDS plus
• Diameter: 1 cm
• Package quantity: 1 piece

How to use

Install the bit into the SDS plus chuck of a compatible rotary hammer until it locks. Select an appropriate drill mode (rotary or rotary hammer) and start drilling at moderate pressure, allowing the bit to clear debris through its flutes. Periodically withdraw the bit to remove accumulated dust and prevent overheating. Maintain steady alignment with the centring tip for precise hole placement and diameter control.

Recommendations

Use personal protective equipment (safety glasses, ear protection and dust mask) and secure the workpiece before drilling. For best results in reinforced concrete, use intermittent drilling and allow the bit to cool if excessive heat or wear appears. Replace the bit once accuracy or cutting performance declines.