CableMod C-Series Pro ModMesh 16-pin naar 4×8-pin gesleevede kabel voor Corsair Type 3/4 voedingen, 60 cm, wit

The CableMod C-Series Pro ModMesh 16‑Pin to 4×8‑Pin Sleeved Cable for Corsair Type 3/4 PSUs is an adapter cable designed to convert a single 16‑pin (12V‑2x6) connector into four separate 8‑pin connectors compatible with PCIe and CPU power inputs. With a length of 60 cm and white ModMesh sleeving, the cable offers a balance of functionality and clean cable management for ATX and HTPC enclosures. It is intended for use with Corsair Type 3 and Type 4 power supplies that support the 16‑pin standard, enabling connection of multiple GPUs or supplying additional CPU power rails while maintaining tidy routing and a coordinated appearance.

Advantages

The sleeved ModMesh construction provides durable protection and a consistent aesthetic across cable runs, improving airflow and reducing clutter inside the case. Four 8‑pin outputs allow flexible power distribution for multi‑GPU setups or systems requiring additional CPU connectors, while the 60 cm length accommodates typical routing paths without excess slack. Compatibility with Corsair Type 3 and Type 4 PSUs ensures a plug‑and‑play connection where the 16‑pin interface is supported.

Suitable for

• Systems with Corsair Type 3 or Type 4 power supplies that use the 16‑pin power output
• Multi‑GPU builds requiring multiple 8‑pin PCIe connectors
• High‑power CPU setups needing additional 8‑pin CPU power rails
• Builders seeking neater cable management and a white sleeved aesthetic inside ATX or HTPC cases

Key specifications

• Connector conversion: 16‑pin (12V‑2x6) to four 8‑pin connectors suitable for PCIe and CPU power inputs
• Cable length: 60 cm overall for typical internal routing
• Sleeving: White ModMesh sleeved outer jacket for protection and consistent appearance
• Compatibility: Designed for Corsair Type 3 and Type 4 power supplies with the 16‑pin output standard

How to use

Connect the single 16‑pin end of the adapter to the corresponding 16‑pin output on a compatible Corsair Type 3 or Type 4 power supply, making sure the orientation matches the PSU header. Route the sleeved cable through the case along planned cable channels or tie‑down points to minimize interference with fans and components. Plug each 8‑pin connector into the intended PCIe or CPU power sockets on the motherboard or graphics cards, ensuring secure seating. Verify all connections before powering on the system.

Recommendations

Use this cable only with compatible Corsair Type 3 or Type 4 PSUs that provide the 16‑pin interface. Confirm the power requirements of GPUs and CPUs and ensure the PSU can supply sufficient combined current on the converted rails. Avoid sharp bends near the connector ends and secure the cable with cable ties or routing channels to prevent strain on connectors.