Coax-antennekabel Omnitronic TNC-set 10 m, TNC-stekker–bus, 10 meter

Omnitronic TNC-Set 10 m is a 10-meter coaxial antenna cable with TNC male-to-female connectors, created for RF signal transmission between devices that use TNC interfaces. The cable provides a fixed-length connection suitable for antennas, wireless routers, radio receivers/transmitters and measurement equipment where a reliable, plug-and-play TNC link is required.

Advantages

The cable combines a shielded coaxial construction with TNC male and TNC female connectors to maintain consistent RF performance across the 10 m run. Its standardized connectors ensure mechanical stability and repeatable electrical contact, and the fixed length simplifies planning and installation in racks, test benches or wall-mounted setups. The product is intended for straightforward, low-maintenance use without the need for additional adapters when both ends accept TNC connections.

Suitable for

Key specifications

How to use

Verify that both devices have compatible TNC connectors before connecting. Align the TNC male and female connectors, push together and screw the coupling nut until hand-tight to ensure proper mechanical and electrical contact. Route the cable to avoid sharp bends and excessive tension; maintain a gentle bend radius appropriate for coaxial cables. For outdoor or exposed installations, use additional weatherproofing at the connector interfaces as required by the installation environment.

Recommendations

Check connector tightness periodically and avoid over-tightening. When installing near other signal cables, maintain separation to reduce potential interference. For critical RF measurements, verify cable performance and continuity with suitable test equipment before relying on the connection.