Glasvezel-transceivermodule BlueOptics 7SN-000 1250 Mbit/s SFP 1310 nm

The BlueOptics 7SN-000 is a fiber optic transceiver module in an SFP form factor, offering a maximum data transfer rate of 1250 Mbit/s and operating at a wavelength of 1310 nm. Designed for single-mode fiber links, this SFP transceiver provides a compact, hot-pluggable interface suitable for switches, routers and other network devices that accept SFP modules. The module supports reliable optical data transmission for point-to-point connections and is compatible with standard SFP ports.

Advantages

The compact SFP design allows easy installation and replacement without powering down equipment. Operating at 1310 nm and supporting up to 1250 Mbit/s ensures stable performance for a range of metro and access network applications. Compliance with standard SFP interface characteristics helps maintain interoperability with a wide variety of networking hardware. The module’s optical transmission characteristics are suitable for extended reach on single-mode fiber, reducing the need for additional media converters or adapters.

Suitable for

• Single-mode fiber point-to-point links
• Upgrading switches and routers with SFP slots
• Access networks and metro connections requiring 1250 Mbit/s
• Replacing faulty SFP transceivers in existing equipment

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Operating wavelength: 1310 nm
• Optical medium: single-mode fiber
• Form factor: hot-pluggable SFP transceiver

How to use

Install the BlueOptics 7SN-000 into an available SFP slot on a compatible network device while the device is powered on or according to the device manufacturer’s hot-plug guidance. Connect the single-mode fiber cable with the appropriate connector type to the module’s optical port, ensuring correct polarity. Verify link status on the host device and configure port settings as required for 1250 Mbit/s operation. Replace the module by gently pulling it from the SFP cage when necessary, following the host equipment’s procedures.

Recommendations

Use single-mode fiber with proper connectors and keep fiber ends clean to ensure optimal optical performance. Check compatibility with the host device’s supported SFP modules and firmware, and verify link parameters after installation. Store unused modules in anti-static packaging and avoid exposure to contaminants or mechanical stress.