Glasvezel-transceivermodule BlueOptics PSFP-1000-S2LC10-BO 1310 nm LC

The BlueOptics PSFP-1000-S2LC10-BO is a single-mode SFP fiber optic transceiver module designed for 1000BASE-LX applications. It operates at a wavelength of 1310 nm, uses an LC duplex connector and supports optical links over single-mode fiber. The module is compact, lightweight (approximately 20 g) and follows MSA-compliant SFP form-factor dimensions for compatibility with SFP ports on switches, routers and other network equipment.

Advantages

This transceiver offers a standardized SFP interface with LC connectivity and 1310 nm transmit/receive operation suitable for long-reach single-mode links. The module’s silver housing and small form factor simplify installation and hot-plug replacement in rack-mounted or modular equipment. Designed according to common MSA guidelines, it enables interoperability with hardware that supports 1000BASE-LX SFP modules.

Suitable for

• Single-mode fiber Ethernet links up to typical LX distances
• Interconnecting switches, routers and storage systems with SFP ports
• Upgrading or replacing 1000BASE-LX SFP modules in network equipment

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Wavelength: 1310 nm (transmit and receive)
• Connector: LC duplex fiber connector
• Fiber type: Single-mode fiber (SMF)
• Form factor: Hot-pluggable SFP module
• Weight: 0.02 kg
• Housing colour: Silver

How to use

Install the BlueOptics PSFP-1000-S2LC10-BO by inserting the SFP module into an available SFP port on compatible network equipment until it clicks into place, then connect LC duplex single-mode patch cords to the module’s LC ports. Ensure the transmit (TX) and receive (RX) fibers are correctly oriented between link endpoints. After physical installation, verify link status and configuration in the host device management interface and enable any required port settings for 1000BASE-LX operation.

Recommendations

Use low-loss single-mode fiber patch cords and, where applicable, proper patch panels or adapters to maintain signal quality. Confirm that the host equipment supports 1000BASE-LX SFP modules and any required diagnostic features before deployment. Handle the module using ESD-safe procedures and keep dust caps on unused fiber connectors to protect optical surfaces.