Kabel EK Water Blocks Loop Connect zwart 1 m

The EK-Loop Connect - USB External Cable 1m is a 1-metre USB A to 4-pin cable designed to link the EK-Loop Connect controller to a PC’s rear USB header. It enables preparatory configuration and direct control of pump, fan and addressable RGB settings from an external computer, making it suitable for modders and builders who need temporary or off-system access to controller functions.

Advantages

This cable provides a standard USB A interface and a 4-pin connector for reliable communication between the EK-Loop Connect controller and a PC. The 1 m length offers flexible placement during setup or photo/video shoots. By connecting to another PC, users can pre-program or run pump, fan and D-RGB LED profiles without booting the target system’s operating system.

Suitable for

• Custom water-cooling system builders who use the EK-Loop Connect controller
• Modders needing to pre-program or test RGB and fan/pump settings externally
• Photographers and videographers who require temporary control of lighting and cooling during shoots

Key specifications

• Connector type: USB A (computer side) to 4-pin (controller side)
• Length: 1 m
• Compatible with: EK-Loop Connect controller units
• Colour: Black

How to use

Connect the USB A end to a standard USB port on the back of a PC and attach the 4-pin end to the EK-Loop Connect controller. Use the PC to access the controller’s software or firmware to program or run desired pump, fan and addressable RGB settings. For temporary use during shoots, leave the target system powered off and operate the controller from the connected PC.

Recommendations

Use a stable USB port on a powered PC and avoid excessive cable bending near the connectors. Ensure the controller model is compatible with the EK-Loop Connect cable before connecting.