KEMO ELECTRONIC M102A lader voor tweede accu 6 - 24 V/DC

The Kemo M102A second battery charger is suitable for lead-acid batteries from 6-24 V/DC.

• 2 batteries connectable
• Max. charging current 10A (with cooling 20A)
• Charge batteries separately from each other
• Connectable batteries: 2 pieces with the same voltage 6-24 V/DC
• Max. charging current: 10A, with cooling max. 20A (total current)

Depending on the load, the module can heat up more or less. The heat is generated on the aluminum plate at the bottom of the module and must be cooled under certain circumstances by mounting on a cooling surface according to the installation instructions. It is important that the module is mounted flat on a cooling, flat cooling plate with 4 screws M3 or sheet metal screws 2.9 mm. This can also be the rear wall of a metal housing. It is important that the aluminum underside of the module does not warp! The screw heads must rest on the sheet metal of the module and not on the plastic edge of the module! During mounting, the module must not warp either (if the surface is not flat). The reason: On the inside of the aluminum base of the module, the electronic SMD components are soldered directly over a thin insulating layer, and if the aluminum base of the module warps, the solder joints come loose and the module becomes defective.

• 1x Kemo M102A second battery charger