KWB nietjes 353008 1400 st. 8 mm beenlengte 1,14 cm kroonbreedte

KWB Hardware Staple 353008 is made from quality steel wire with a C-point tip designed for high pull-out resistance. The staples have an 8 mm leg length and a crown width of 1.14 cm; each pack contains 1400 pieces. They are intended for general fastening tasks in woodworking, upholstery and other light construction and hobby applications where a compact staple is required.

Advantages

The steel wire construction and C-point tip provide reliable penetration and holding power while reducing material splitting. High pull-out resistance increases joint durability. The compact dimensions (8 mm leg, 1.14 cm crown) make these staples suitable for thin materials and precision fastening. The large pack count ensures extended use without frequent replacement.

Suitable for

Key specifications

How to use

Load the staples into a compatible manual or pneumatic stapler sized for 8 mm leg length and a 1.14 cm crown. Position the stapler over the material to be joined and apply steady pressure or trigger the tool according to the stapler manufacturer’s instructions. Ensure the material is supported underneath to avoid deformation and check staple penetration. For repeated tasks, verify alignment and replace the staple strip when empty.

Recommendations

Use these staples with staplers specified for 8 mm leg length and a 1.14 cm crown; avoid using them in very hard or brittle materials without pre-drilling. For textile and upholstery work, test on a scrap piece first to confirm holding and appearance.