LED-buitenlamp met bewegingsmelder MACLEAN MCE244B — LED-lamp met ingebouwde bewegingsmelder

MACLEAN MCE244B is an exterior LED motion sensor lamp designed for automatic, hands-free illumination of outdoor areas. The lamp integrates an LED light source with a built-in motion detector to switch the fixture on when movement is detected. Intended for wall mounting near entrances, pathways, driveways or terraces, this weather-resistant unit provides efficient lighting that balances visibility and energy savings for residential and light-commercial settings.

Advantages

The lamp combines energy-efficient LED technology with an integrated motion sensor to reduce unnecessary runtime and lower electricity consumption. Its compact design allows installation on typical exterior walls without requiring large mounting space. The built-in sensor enables automatic activation and deactivation, improving convenience and safety by illuminating areas only when needed. The construction is suitable for outdoor conditions and supports routine exterior lighting requirements without frequent maintenance.

Suitable for

• Illuminating front and back entrances for improved visibility and security
• Lighting driveways, walkways and paths to assist safe movement at night
• Adding temporary or spot illumination to patios, terraces and small outdoor seating areas
• Use in residential buildings and light-commercial properties such as small offices or storefronts

Key specifications

• Exterior-rated LED fixture with integrated motion detection
• Automatic on/off operation based on detected movement
• Compact wall-mount form factor suitable for typical facade installations
• Low power consumption characteristic of LED lighting
• Durable housing designed for outdoor exposure

How to use

Mount the lamp on a stable exterior wall at the recommended height so the sensor can reliably detect approaching movement. Connect the fixture to the outdoor power supply following local electrical codes and safety procedures; ensure the power is turned off during installation. After wiring and mounting, restore power and test the sensor by moving through the detection zone to confirm automatic switching and adjust the mounting position if necessary to achieve the desired coverage.

Recommendations

Position the lamp to face likely approach routes and avoid direct exposure to other light sources that could reduce sensor effectiveness. For reliable performance, keep the sensor lens clean and periodically check seals and mounting hardware for weather-related wear. If precise timing or sensitivity adjustments are required, consult a qualified electrician or the product manual for configuration options.