Microconnect B-UTP510 netwerkkabel grijs 10 m Cat5e U/UTP (UTP)

The Microconnect B-UTP510 is a 10 m RJ-45 Cat5e networking cable designed for data transfer up to 1000 Mbit/s and tested to the Cat5e standard of 100 MHz. With U/UTP construction and latch protection on the connectors, the cable provides a reliable, interference-resistant connection between devices such as switches, modems, routers or to infrastructure points like patch panels, keystone jacks and wall outlets. Its grey colour suits both home and small office network and entertainment applications.

Advantages

This Cat5e cable is backwards compatible with Cat5 systems and supports 10/100/1000Base-T(X) cabling technology. Latch protection reduces the risk of connector damage during installation in tight spaces, while the U/UTP design helps minimise electromagnetic interference. The 10 m length offers flexible placement of network devices without requiring additional extensions.

Suitable for

• Connecting routers, modems and switches
• Patch panel and keystone jack terminations
• Home networks and small office setups
• Entertainment systems and media devices

Key specifications

• Length: 10 m
• Connectors: RJ-45 — RJ-45
• Standard: Cat5e, tested to 100 MHz
• Cabling technology: 10/100/1000Base-T(X)
• Shielding: U/UTP
• Colour: Grey
• Weight: 0.21 kg
• Brand: MicroConnect, MPN: B-UTP510, EAN: 5711045251382

How to use

Connect one RJ-45 end to your network device (router, switch or modem) and the other end to the destination point such as a patch panel, keystone jack or wall outlet. Ensure connectors are fully inserted until the latch clicks. Route the cable avoiding sharp bends and sources of strong electromagnetic interference to maintain signal quality.

Recommendations

For best performance, avoid running the cable parallel to power lines for long distances and keep bend radius consistent with standard cabling practice. Use this Cat5e cable for typical gigabit Ethernet links within homes and small offices; replace with Cat6 or higher only if higher bandwidth or reduced crosstalk is required.