Netwerkkaart MicroConnect I210-F1 PCIe x1 10/100/1000 Mbit/s

MicroConnect I210-F1 PCIe x1 10/100/1000 Mbps is a single-port Gigabit Ethernet expansion card for desktop or server systems. It fits into a standard PCI Express x1 slot and provides a wired network interface supporting 10/100/1000 Mbps speeds. The card uses hardware-based processing to offload network tasks from the host CPU and is suitable for upgrading older systems or replacing a malfunctioning integrated network interface.

Advantages

The MicroConnect I210-F1 delivers reliable wired connectivity with support for Gigabit Ethernet speeds and backward compatibility with 10/100 Mbps networks. Its PCIe x1 form factor enables installation in systems with limited expansion slots while maintaining low power consumption and stable performance. Hardware-assisted packet processing improves throughput and reduces CPU load, and broad driver support ensures compatibility with common desktop and server operating systems.

Suitable for

• Upgrading legacy desktops or servers to Gigabit Ethernet
• Replacing a failed onboard network interface
• Adding a reliable wired port for office workstations
• Small server or NAS network expansion where a single additional port is needed

Key specifications

• Interface: PCI Express x1
• Network speeds: 10/100/1000 Mbps (Gigabit Ethernet)
• Ports: 1 × RJ-45 Gigabit Ethernet
• Media support: Auto MDI/MDIX, full- and half-duplex modes
• Offload features: hardware-based packet processing to reduce CPU utilization
• Compatibility: standard desktop and server PCIe x1 slots
• Physical profile: low-profile bracket option for small form-factor systems (if applicable)

How to use

Power down the computer and disconnect it from mains. Open the chassis according to the system manufacturer’s instructions, locate an available PCI Express x1 slot and remove the corresponding expansion slot cover. Insert the MicroConnect I210-F1 card into the slot firmly until it is fully seated, secure the card with the slot screw, close the chassis and reconnect power. Boot the system and install the appropriate network drivers provided by the operating system or downloaded from the vendor. Connect an Ethernet cable to the RJ-45 port and configure network settings in the OS network control panel or management interface.

Recommendations

For stable Gigabit performance use Cat5e or higher-rated Ethernet cable and connect to a Gigabit-capable switch or router. Ensure system BIOS and OS are updated and install vendor-recommended drivers for optimal compatibility and feature support. When installing in small form-factor systems, verify the card’s bracket type fits the chassis and replace with a low-profile bracket if required.