Netwerkkabel Lindy 7,5m RJ-45 Cat6 U/UTP groen

The Lindy 7.5m RJ-45 Cat6 U/UTP Green network cable is a Cat.6 unshielded twisted pair (U/UTP) cable designed for operating frequencies up to 250 MHz and supporting Ethernet speeds up to 1GBase-T. It features RJ-45 connectors on both ends, gold-plated contacts for corrosion resistance, a snagless strain relief design to protect the connector latch during installation and removal, and is supplied individually in a polybag.

Advantages

This Cat.6 U/UTP cable provides performance up to 250 MHz while remaining unshielded, enabling Gigabit Ethernet use through optimized electrophysical parameters (such as NExT and FExT). Gold-plated contacts ensure reliable, low-corrosion connections over long-term use. The snagless connector design reduces the risk of damage to the latch during plugging and unplugging. The cable is manufactured and tested according to ISO/IEC 11801 standards and comes in a distinctive green color.

Suitable for

• Gigabit Ethernet connections (1GBase-T)
• General office and home networking
• Patch panels and wall ports with RJ-45
• Temporary and permanent network cabling runs up to 7.5 m

Key specifications

• Category: Cat.6 U/UTP
• Operating frequency: up to 250 MHz
• Length: 7.5 m
• Connectors: RJ-45 — both ends
• Contacts: gold-plated
• Cabling technology: 10GBase-T (backward compatible with 1GBase-T)
• Colour: Green
• Standards: manufactured and tested to ISO/IEC 11801

How to use

Connect one RJ-45 connector to your network device (router, switch, computer or patch panel) and the other RJ-45 connector to the corresponding port. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid tight bends and sharp edges; the snagless strain relief helps protect the connector during handling. For best performance, keep the cable away from strong electrical interference sources and avoid excessive stretching or crushing.

Recommendations

For reliable Gigabit performance, use the cable for patching and short horizontal runs up to 7.5 m and follow standard cabling practice: maintain bend radius, avoid running parallel to power lines, and test connections after installation. Replace if connectors or cable jacket show visible damage.