Netwerkkabel LOGON Cat6 UTP 15m, RJ-45 naar RJ-45, groen

LOGON Cat6 UTP 15m networking cable is an unshielded twisted-pair Ethernet patch lead designed for wired LAN and Gigabit Ethernet connections. The cable is 15 metres long and terminated with RJ-45 connectors on both ends. Its green jacket provides easy visual identification in patch panels, server racks and multi-cable environments. Constructed to Cat6 performance parameters, this cable supports reliable data transmission for typical home, office and small data-centre installations.

Advantages

The LOGON Cat6 UTP cable features 4 x 2 AWG 26/7 twisted pairs with 100 Ω characteristic impedance and a rated frequency of 250 MHz, ensuring stable signal integrity up to Cat6 class limits. Each end is fitted with an RJ-45 male connector and a boot with kink protection and strain relief to reduce wear at the connector entry. The cable is Category 6 certified (3P Category 6), uses a 1:1 wiring pattern and includes a spot length marking on the boot for convenient cable management and installation verification.

Suitable for

• Gigabit Ethernet and 10/100/1000BASE-T LAN connections
• Home networks, office workstations and VoIP phone connections
• Patch panels, switches and router interconnections in server racks
• Temporary or permanent cabling runs where a distinct cable colour is needed

Key specifications

• Cable category: Cat6 UTP (unshielded twisted pair)
• Length: 15 m
• Conductor: 4 x 2 AWG 26/7 stranded
• Characteristic impedance: 100 Ω
• Rated frequency: 250 MHz
• Connectors: RJ-45 male on both ends
• Wiring: 1:1 (straight-through)
• Boot: integrated kink protection and strain relief with spot length marking
• Colour: green

How to use

Route the LOGON Cat6 UTP cable between network devices ensuring bends exceed the minimum bend radius and avoiding tight loops or sharp edges. Insert the RJ-45 male connectors fully into the device or patch panel ports until the latch clicks. Secure cabling runs in racks or along walls using appropriate cable management to prevent tension on the connectors. The 1:1 wiring suits standard straight-through connections between devices such as switches to workstations or routers to switches.

Recommendations

For best performance, keep the cable away from sources of strong electromagnetic interference, avoid kinking, and do not exceed recommended bend radii. Verify link speed and cable continuity after installation using a network tester if required. Use the cable’s green colour to label or segregate specific network segments for easier maintenance.