Netwerkkabel Schwaiger CKB6100 052 RJ-45 Cat6 10 m wit

The Schwaiger CKB6100 052 networking cable is a Cat6 patch cable with a 10 m length and RJ-45 connectors on both ends. Constructed with SF/UTP shielding, the cable reduces electromagnetic interference and is designed for reliable wired connections in home and small office networks. It supports data transmission up to 1000 Mbit/s and has a white jacket for a discreet, professional appearance.

Advantages

SF/UTP shielding enhances protection against external interference while maintaining flexibility for installation. Cat6 specification provides improved performance over earlier categories for gigabit Ethernet and stable signal integrity across typical LAN distances. Factory-terminated RJ-45 plugs simplify installation and provide a consistent, secure connection. The 10 m length covers longer runs without requiring additional couplers or extensions.

Suitable for

• Connecting PCs, switches and routers in home or office LANs
• Wired gigabit Ethernet connections for media streaming and file transfers
• Network wall outlets and patch panels where a clean white cable is preferred
• Temporary network setups and structured cabling where 10 m reach is required

Key specifications

• Category: Cat6
• Shielding: SF/UTP (screened foil with unshielded twisted pairs)
• Connectors: RJ-45 on both ends
• Length: 10 m
• Colour: White
• Maximum data rate: up to 1000 Mbit/s

How to use

Route the cable between network devices avoiding sharp bends and sources of strong electromagnetic interference. Insert RJ-45 connectors fully into the network ports of devices such as switches, routers and computers until the latch clicks. For wall or rack installations, secure the cable along cable management channels or ties to prevent strain on connectors. Test the connection with network diagnostic tools or the operating system network status to confirm link speed and stability.

Recommendations

For best performance, maintain gentle bend radii, avoid running the cable in parallel with high-voltage power lines, and use shielded patch panels or properly grounded equipment when integrating SF/UTP cabling into an existing infrastructure.