Satelliet-tv-systeem SCHWAIGER SPI9962SET9 voor 4 deelnemers, 80 cm schotel

SCHWAIGER SPI9962SET9 is a satellite TV system designed to receive and distribute satellite television signals to up to four receivers. The set includes an 80 cm parabolic dish engineered to capture satellite broadcasts with stable performance for home or small multi-room installations. The system supports sharing a single satellite feed across four endpoints, enabling simultaneous viewing on multiple receivers when properly installed and configured.

Advantages

The 80 cm parabolic reflector provides a balance between signal gain and compact size, suitable for typical residential roof or wall mounting. The system is designed for multi-receiver distribution, reducing the need for separate dishes for each receiver and simplifying cabling for small installations. Components are matched to ensure consistent signal quality to each of the four outputs when aligned and set up according to installation guidelines.

Suitable for

• Single-dish distribution of satellite TV to four receivers in a home
• Small apartments or houses with multiple rooms requiring independent satellite receivers
• Secondary installations where space or mounting options are limited but reliable reception is needed
• Users who want a consolidated satellite system without separate dishes for each tuner

Key specifications

• Dish diameter: 80 cm parabolic reflector for standard satellite reception
• Distribution capability: up to 4 receiver outputs for simultaneous connections
• Design: compact outdoor satellite antenna suitable for residential mounting
• Intended reception: standard satellite TV frequency ranges for typical consumer receivers
• Installation: includes components for mounting and cabling to feed four endpoints (receiver compatibility depends on receiver requirements)

How to use

Mount the 80 cm dish on a suitable stable support such as a roof mast or wall bracket with a clear line of sight to the target satellite position. Align the dish azimuth and elevation according to local satellite coordinates and tighten mount fittings to secure the dish. Connect the LNB and distribution cabling from the dish to the multi-output splitter or distribution unit, then run coaxial cables to each of the four receivers. Configure each receiver using its setup menu to scan and store available satellite channels. Verify signal strength and quality on each receiver and make fine adjustments to the dish alignment if necessary to optimize reception.

Recommendations

For reliable long-term operation, use low-loss coaxial cables and weatherproof connections. Perform alignment using a signal meter or receiver signal indicators, and check that the dish has unobstructed view of the satellite. If signal strength varies between outputs, inspect splitters and cable terminations and replace damaged connectors. Consider professional installation if mounting at height or if accurate alignment tools are not available.