SFP-transceiver BlueOptics AFBR-5705LZ-BC-BO 1250 Mbit/s glasvezel

The BlueOptics AFBR-5705LZ-BC-BO SFP transceiver is a small-form pluggable module intended for fiber optic network links with a maximum data transfer rate of 1250 Mbit/s. Its SFP form factor and silver housing make it compatible with a wide range of switches, routers and media converters that accept standard SFP modules. The module is lightweight (approx. 20 g) and complies with CE, FCC and RoHS requirements, with an estimated MTBF of 1,000,000 hours to indicate expected reliability.

Advantages

This SFP transceiver provides a standardized interface for fiber optic connections, supporting up to 1250 Mbit/s data transfer. The compact SFP form factor simplifies installation and replacement in compatible networking equipment. Certification to CE, FCC and RoHS ensures conformity with common regulatory and environmental expectations, while the specified MTBF gives an indication of long-term operational stability.

Suitable for

• Replacing or upgrading SFP ports on switches and routers
• Establishing fiber links between network devices in local and campus networks
• Use in media converters or fiber-capable network appliances

Key specifications

• Form factor: SFP
• Maximum data transfer rate: 1250 Mbit/s
• Product colour: Silver
• Weight: 0.02 kg
• Regulatory compliance: CE, FCC, RoHS
• Estimated MTBF: 1,000,000 hours

How to use

Power down or follow hot-swap procedures recommended by the host device before inserting the SFP module. Align the module with the SFP cage and insert until it clicks into place; secure any latch or retention mechanism if present. Connect the appropriate fiber optic cable to the transceiver port, ensuring correct connector type and clean end-faces. Verify link status via the host device indicators or management interface and configure interface settings such as speed and duplex if required by the network equipment.

Recommendations

Use appropriate ESD precautions when handling the transceiver and keep optical connectors capped when not in use. Clean fiber connectors before insertion to avoid signal loss. Ensure compatibility with the host device’s supported SFP modules and confirm link parameters after installation.