SFP+-transceiver BlueOptics BO35J13610D (980-9I79O-00G000-BO) — LC-duplex, 10GBASE-LR, singlemode, 1310nm, 10 km, 0–+70°C

BlueOptics BO35J13610D SFP+ transceiver is a single‑mode fiber optic module designed for 10 Gigabit Ethernet long‑reach links. The module uses an LC‑duplex interface and transmits at a wavelength of 1310 nm, providing reliable single‑mode performance up to 10 km. It is intended for installation in switches, routers and media converters that accept SFP+ form‑factor modules and operate within an ambient temperature range of 0°C to +70°C.

Advantages

The transceiver supports 10GBASE‑LR signaling over single‑mode fiber, enabling extended reach for backbone and inter‑building connectivity. Its LC‑duplex connector ensures broad compatibility with standard single‑mode patch cables. With an industrial operating temperature range and SFP+ form factor, the module offers simple hot‑plug installation and interoperability with equipment that conforms to common SFP+ interfaces.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on a switch, router or media converter until it latches. Connect LC‑duplex single‑mode patch cables to the transceiver ensuring correct Tx/Rx orientation. Configure the network device interfaces according to vendor guidance to enable 10GBASE‑LR operation; many platforms automatically negotiate link parameters for SFP+ modules. Monitor link LEDs and device diagnostics to verify successful optical link establishment and signal quality.

Recommendations

For reliable performance, use ITU‑T compliant single‑mode fiber with appropriate attenuation budget and maintain clean fiber connectors. Observe ESD handling precautions when installing the module and avoid bending fiber beyond the specified minimum bend radius. Check compatibility notes of the host device for supported SFP+ modules and firmware requirements before deployment.