SFP transceiver module BlueOptics SFP-10G-LRM-SW 10000 Mbit/s 1310 nm

The BlueOptics SFP-10G-LRM-SW is a compact SFP+ fiber optic transceiver module engineered for 10 Gbit/s Ethernet links. Operating at a 1310 nm wavelength, this module supports high-speed short-reach multimode fiber connections and is intended for use in network switches, routers and optical uplinks that accept SFP+ ports. The transceiver is lightweight and designed for easy hot-pluggable installation into compatible networking equipment.

Advantages

The module provides a reliable 10 Gbit/s data rate over multimode fiber using a 1310 nm optical wavelength, combining small form-factor compatibility with common SFP+ interfaces. Its compact SFP+ design enables straightforward integration into existing ports without requiring adapter cages. The silver, lightweight housing contributes to efficient rack and chassis installations while maintaining standardized mechanical and electrical characteristics for interoperability.

Suitable for

• 10 Gigabit Ethernet short-reach multimode fiber links
• Optical uplinks between switches and routers with SFP+ ports
• Data center server-to-switch connections and aggregation links
• Network equipment upgrades where SFP+ modules are required

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1310 nm
• Form factor: SFP+ hot-pluggable transceiver
• Typical application: short-reach multimode fiber connections
• Weight: approximately 0.02 kg
• Colour: silver

How to use

Power down is not required for hot-pluggable SFP+ modules; align and insert the transceiver into an empty SFP+ slot until it seats and the latch engages. Connect the appropriate multimode fiber patch cable with compatible LC connectors to the module's optical interface. Verify link and speed status via the host device's management interface and ensure fiber polarity and transceiver settings (such as duplex and speed auto-negotiation where applicable) match the network configuration.

Recommendations

Handle the transceiver by its housing, avoid touching the optical interfaces, and keep dust caps in place when not connected. Use multimode fiber rated for 1310 nm and verify compatibility with the host equipment's supported SFP+ modules and firmware. For reliable operation, follow standard electrostatic discharge (ESD) precautions and install in environments within the equipment manufacturer's recommended temperature and humidity ranges.