SFP-transceivermodule BlueOptics 1113081-BO 1250 Mbit/s

The BlueOptics 1113081-BO SFP transceiver module is a compact fiber optic interface designed for use in network media converters, switches and routers that accept SFP modules. It supports a maximum data transfer rate of 1250 Mbit/s over single‑mode fiber and uses an LC (UPC) connector in a silver metal housing. With a rated maximum link distance of up to 40,000 m and a high MTBF, the module provides a lightweight, hot‑pluggable option for establishing point‑to‑point optical links in enterprise and telecom environments.

Advantages

The module offers a standardized SFP form factor for wide device compatibility and a compact silver housing that facilitates installation in dense rack environments. Its support for 1.25 Gigabit Ethernet data rates and an LC (UPC) fiber connector ensures stable optical connectivity. The listed mean time between failures of 1,000,000 hours indicates long service life and reduced replacement frequency, while a weight of approximately 20 g keeps the module lightweight and easy to handle during installation.

Suitable for (tasks / use cases)

• Single‑mode fiber point‑to‑point links up to 40 km
• Replacing or upgrading SFP ports in switches and routers
• Interconnecting media converters and optical network devices
• Environments requiring hot‑swappable optical transceivers

Key specifications

• Data rate: 1250 Mbit/s (1.25 Gbit/s)
• Maximum transfer distance: 40,000 m (40 km)
• Interface type: 1.25 Gigabit Ethernet (SFP)
• Fiber connector: LC (UPC)
• Housing colour: Silver
• Weight: 0.02 kg
• Hot‑pluggable SFP form factor

How to use

Power down the device if recommended by the manufacturer, align the SFP module with the SFP slot and insert it gently until it clicks into place. Connect a properly terminated LC optical fiber cable to the module's LC (UPC) connector, observing correct fiber polarity. After insertion, verify link status and signal levels via the host device's management interface or LEDs. For removal, disconnect the fiber cable first, then press the release latch and pull the module straight out.

Recommendations

Use single‑mode LC (UPC) fiber cables rated for the intended link distance and ensure connectors are clean before mating. Match transceiver transmit and receive wavelengths and confirm device compatibility with SFP modules. Store unused modules in anti‑static packaging and avoid exposure to excessive dust or moisture.