SFP+-transceivermodule BlueOptics BO35J13640D-BO 10000 Mbit/s

The BlueOptics BO35J13640D-BO is a single‑mode SFP+ transceiver module for 10GBASE-ER links. It uses an LC duplex connector and operates at 1310 nm for both transmitter and receiver, supporting data rates up to 10 Gbit/s over distances up to 40 km. The module is housed in metal for durability, weighs 20 g and has an MTBF of approximately 1,000,000 hours. It includes Digital Diagnostics Monitoring (DDM/DOM) for real‑time monitoring of supply voltage, laser bias current, transmit power, receive power and temperature.

Advantages

The BlueOptics BO35J13640D-BO offers MSA-compliant form factor and electrical interface for broad interoperability with switches, routers, storage systems and other SFP+-compatible hardware. Components from established suppliers are used to achieve long service life and stable optical performance. Built‑in DDM simplifies remote monitoring and troubleshooting. The LC duplex connector enables simultaneous transmit and receive on separate fibers for reliable single‑mode links up to 40 km.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP+ slot of a compatible switch, router or storage device following the host vendor's hot‑plug guidance. Connect LC duplex single‑mode patch cords between transceivers on both ends, ensuring correct Tx↔Rx fiber alignment. Verify that the host device recognizes the module and that DDM/DOM is enabled if you require diagnostic telemetry. Perform link tests and monitor optical power and temperature to confirm proper operation.

Recommendations

Use high‑quality single‑mode LC patch cords and, where possible, matching BlueOptics patch panels or transceivers to achieve optimal link performance. Ensure the host hardware supports DDM/DOM to utilize diagnostic features. For long links, verify fiber attenuation and connector cleanliness before commissioning.