BlueOptics SFP+ transceiver BO35J856S3D 10G 850nm Multimode

BlueOptics SFP+ transceiver BO35J856S3D 10G 850nm multimode is a compact optical module for 10 Gigabit Ethernet links over multimode fiber. Designed for use in SFP+ ports, the transceiver supports short-range data transmission at a wavelength of 850 nm and is intended for deployment in data center server uplinks, switch-to-switch connections and campus network interconnects. The module fits standard SFP+ sockets and allows hot-swap replacement without interrupting powered equipment.

Advantages

This 10G multimode SFP+ transceiver delivers reliable short-range connectivity with low power consumption and stable optical performance. Its form factor ensures compatibility with a wide range of switches, routers and media converters that accept SFP+ modules. The 850 nm VCSEL-based design provides cost-effective transmission for multimode fiber runs, and the module’s compact plug-and-play nature enables quick installation and maintenance.

Suitable for

Key specifications

How to use

Insert the transceiver into a compatible SFP+ port until it clicks into place, then connect the multimode duplex fiber cable with the correct LC connectors. Ensure the networking device is configured for a 10 Gigabit link and verify link status through the switch or router management interface. For hot-swap replacement, remove the module using the release latch while observing ESD precautions and insert the new module without powering down connected equipment if the device supports hot swapping.

Recommendations

Use multimode fiber of appropriate grade (for example OM3 or OM4) to achieve expected reach and performance. Observe ESD precautions when handling the transceiver, keep optical connectors clean and use dust caps when not connected to prevent contamination. Verify compatibility with the host device’s SFP+ port and firmware to ensure proper operation.