SFP-transceivermodule BlueOptics SFP-10B-CM-BO 1250 Mbit/s

The BlueOptics SFP-10B-CM-BO 1250 Mbit/s is a compact fiber optic SFP transceiver module designed for single-mode fiber links. Housed in a metal casing with a steel finish and weighing just 20 g, this module supports a maximum data transfer rate of 1250 Mbit/s and operates from a 3.3 V supply. With LC simplex optical connectivity and compliance with SFP/ MS A mechanical form factors, the module is intended for use in network equipment that accepts standard SFP transceivers.

Advantages

The module offers a standardized SFP interface for easy hot-swap installation and wide compatibility with switches, routers and storage systems that accept SFP modules. Its metal housing provides mechanical robustness and EMI shielding, while the low weight and small form factor minimize space and cooling requirements. Designed according to industry MSA guidelines, it supports reliable optical transmission over single-mode fiber and includes digital diagnostics (DDM/DOM) capability when supported by host hardware for real-time monitoring of supply voltage, laser bias, output and received power, and temperature.

Suitable for

Key specifications

How to use

Insert the SFP transceiver into a compatible SFP slot on the network device while the device is powered on or according to the host equipment’s hot-swap guidelines. Connect an LC simplex single-mode fiber patch cable to the module’s optical port; ensure correct pairing for single-fiber BX operation (matching Tx/Rx wavelengths between transceivers). Verify that the host device recognizes the module and, if required, enable or check DDM/DOM monitoring in the device management interface. Observe the device and link status LEDs or management console to confirm link activity.

Recommendations

Use high-quality single-mode LC simplex patch cords and, when deploying single-fiber BX modules, ensure the remote transceiver matches the required Tx/Rx wavelength arrangement. Verify that the host device firmware supports third-party SFP modules and DDM/DOM if diagnostic monitoring is needed. Follow standard fiber handling procedures: keep connectors clean, avoid sharp bends, and secure cables to prevent strain on the transceiver. For extended reach and optimal performance, install per the equipment vendor’s optical budget and link-loss calculations.