SFP-transceivermodule BlueOptics SFP-10G-LRM-CI 10000 Mbit/s 1310 nm

The BlueOptics SFP-10G-LRM-CI is a compact SFP+ fiber optic transceiver module engineered for 10 Gbit/s links over multimode fiber. Operating at a central wavelength of 1310 nm, this transceiver supports reliable data transmission up to 300 metres when used with appropriate multimode fiber and compliant link partners. Its SFP+ interface makes it compatible with a wide range of switches, routers and optical equipment that accept SFP/SFP+ modules. The module is lightweight (approx. 20 g) and finished in a silver housing suitable for standard rack and chassis deployments.

Advantages

This transceiver provides 10 Gbit/s performance with a small form factor, enabling high-speed connectivity while conserving port density. The 1310 nm wavelength and LRM specification are intended for multimode fibre runs where moderate distances are required without wavelength conversion. The SFP+ interface ensures interoperability with equipment supporting SFP/SFP+ sockets, and the compact silver housing simplifies integration into network racks and patch panels.

Suitable for

• 10 Gbit/s multimode fiber links in data centre access and aggregation
• Short- to mid-range connections up to 300 m over appropriate multimode fiber
• Switches, routers and optical appliances with SFP/SFP+ ports
• Upgrades where port density and low weight are beneficial

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 1310 nm
• Reach: up to 300 metres over suitable multimode fiber
• Form factor: SFP+ transceiver module
• Weight: approx. 0.02 kg
• Housing colour: silver

How to use

Install the BlueOptics SFP-10G-LRM-CI into an available SFP/SFP+ slot on compatible network equipment while the host device is powered according to the manufacturer's instructions. Use correct multimode fiber cables and compatible duplex LC connectors; ensure fiber polarity and patching follow standard practices. After insertion, verify link status and configure port settings (speed, duplex, auto-negotiation) in the host device console to match the network design. Remove the module by powering down or following hot-swap procedures indicated by the equipment vendor and using the module's eject mechanism.

Recommendations

Use this transceiver with multimode fiber that meets the LRM application requirements and with network devices that explicitly support SFP+ modules. Avoid exposing the optical interface to dust or direct contaminants; keep protective caps on when the module is not connected. For optimal performance, verify compatibility with the switch or router vendor and confirm link budgets for runs approaching the 300 m limit.