SSD Transcend 32 GB mSATA SATA III TS32GMSA370S

The Transcend TS32GMSA370S is a 32GB mSATA SSD compatible with the SATA III 6Gb/s interface. Designed for space-constrained portable devices such as Ultrabooks, tablet PCs and slim servers, this compact solid-state drive uses MLC technology and a dedicated controller to provide reliable storage with a maximum interface transfer rate of 6 Gbit/s and measured sequential read/write speeds of up to 280 MB/s and 50 MB/s respectively.

Advantages

The mSATA form factor allows installation in devices with limited space while reducing power consumption compared to traditional drives. MLC NAND and an optimized controller improve endurance and consistent performance for typical laptop workloads. Lightweight construction helps keep portable systems thin and mobile.

Suitable for

• Ultrabooks and thin laptops
• Tablet PCs with mSATA slots
• Slim servers and embedded systems
• Storage upgrades for older notebooks

Key specifications

• Model: Transcend TS32GMSA370S
• Capacity: 32 GB
• Interface: SATA III (6 Gb/s), mSATA form factor
• Sequential read speed: up to 280 MB/s
• Sequential write speed: up to 50 MB/s
• NAND type: MLC
• Weight: 0.008 kg

How to use

Power off the host device and open the access panel according to the manufacturer’s instructions. Locate the mSATA slot and insert the SSD at the correct angle, then secure it with the mounting screw. Close the device, power it on, and initialize/format the drive in the operating system if required. For system migration, use disk-cloning software compatible with your OS to copy data from the existing drive to the Transcend mSATA SSD.

Recommendations

Install firmware updates from Transcend when available, enable TRIM support in the operating system, and avoid abrupt power loss during write operations to maintain performance and prolong the SSD’s service life.