Teltonika 4-pin-naar-4-pin-stroomkabel, Zwart, 1 m, ingangsspanning 30 V, ingangsstroom 2 A

The Teltonika 4-pin to 4-pin power cable Black 1 m is a compact power lead designed to provide a reliable connection between compatible devices. With a 1 meter length and a rated maximum input voltage of 30 V and input current of 2 A, this cable is intended for low-voltage power delivery where consistent contact and minimal signal loss are required. The cable's 4-pin female/male interface supports secure mating and straightforward installation in equipment that accepts the same connector type.

Advantages

This power cable offers a standardized 4-pin connection that simplifies replacements and installations. The 1 m length balances reach and cable management, reducing excess cable clutter while allowing practical placement of devices. Rated for up to 30 V and 2 A, it is suitable for a range of low-power applications and provides stable current delivery when matched with compatible power sources and devices.

Suitable for

• Powering networking equipment and telematics devices with a 4-pin connector
• Replacing existing 4-pin to 4-pin power leads of similar size
• Desktop or rack installations where a short, reliable power cable is required
• Laboratory or testing setups that need repeatable low-voltage power connections

Key specifications

• Connector type: 4-pin to 4-pin
• Colour: Black
• Length: 1 m
• Maximum input voltage: 30 V
• Maximum input current: 2 A
• Intended use: Low-voltage DC power delivery

How to use

Inspect both the cable and device connectors for damage or debris before connection. Align the 4-pin connectors and insert firmly until secure; ensure proper polarity and mating orientation according to the receiving device's connector markings. Connect the other end to the power source rated within the cable's maximum voltage and current limits. Avoid forcing the connector and do not exceed the specified 30 V or 2 A ratings. When disconnecting, pull on the connector body rather than the cable to prevent stress on the wires.

Recommendations

Use the cable only with devices and power supplies that match the 4-pin connector and do not exceed 30 V or 2 A. Route the cable away from sharp edges, hot surfaces and moving parts. For installations with higher current or voltage requirements, select a cable and connectors rated appropriately. Regularly inspect the cable for wear and replace if insulation or connector integrity is compromised.