XFP-transceivermodule BlueOptics XFP-10G-L-OC192-SR1 10000 Mbit/s 1310 nm

The BlueOptics XFP-10G-L-OC192-SR1 is an XFP transceiver module engineered for 10 Gbit/s fiber optic links. Operating at 1310 nm, this module supports data transmission up to 10000 Mbit/s and is specified for reach up to approximately 300 meters over suitable multimode or short-reach single-mode fiber, depending on cable and network conditions. The XFP form factor provides a hot-swappable interface compatible with devices that accept XFP modules, enabling use in switches, routers and optical line equipment that require a compact 10G optical uplink.

Advantages

The module offers a standardized XFP interface for wide device compatibility and straightforward installation. Its 1310 nm wavelength and 10 Gbit/s throughput make it appropriate for short-to-medium distance aggregation links and data center interconnects where low-latency, high-bandwidth connections are required. The transceiver is hot-pluggable, reducing maintenance downtime, and its compact form factor saves rack and port space in equipment that supports XFP modules.

Suitable for

Key specifications

How to use

Insert the BlueOptics XFP module into a compatible XFP port while the host device is powered on or per the equipment vendor’s hot-swap guidance. Ensure correct orientation and that the module seats fully in the cage until it latches. Connect appropriate fiber patch cords with matching connectors and ensure polarity is correct. Verify link status and speed in the host device management interface and monitor optical power and error counters to confirm a healthy link. Follow the switch or router vendor’s instructions for enabling and configuring the corresponding interface.

Recommendations

Use factory-tested fiber patch cables of the correct type (multimode or single-mode as applicable) and maintain clean connector end-faces to avoid signal degradation. Confirm compatibility with the host device’s XFP port and firmware. For reliable operation, observe manufacturer guidelines for allowable temperature, handling, and ESD precautions.