ACT 3 m LSZH multimode 62,5/125 OM1 glasvezel-patchkabel duplex met LC-stekkers

Fiber patch cable duplex LC connectors ACT 3 meter LSZH Multimode 62.5/125 OM1 is a 3-meter multimode optical patch cable with duplex LC-LC connectors and 62.5/125 µm OM1 fiber. The cable jacket is LSZH (Low Smoke Zero Halogen), suitable for indoor installations where reduced smoke and toxic gas emission are required. The duplex LC connectors support full-duplex transmission for connecting switches, patch panels and other network equipment.

Advantages

This multimode OM1 fiber patch cable provides reliable multimode data transmission over short to medium distances and comes with standardized LC duplex connectors for broad compatibility. The LSZH jacket reduces hazardous emissions in confined spaces and meets common safety requirements for indoor cabling. The 3-meter length offers flexible placement in racks and patch cabinets while maintaining signal integrity.

Suitable for

• Connecting switches, servers and patch panels in data cabinets
• Indoor fiber runs in offices, server rooms and telecom closets
• Full-duplex links between network devices using LC interfaces

Key specifications

• Connector type: LC-LC duplex
• Fiber type: Multimode OM1 (62.5/125 µm)
• Length: 3 m
• Jacket: LSZH (Low Smoke Zero Halogen)
• Brand / MPN / EAN: ACT / RL9003 / 8716065171099

How to use

Verify both ends of the link are powered down or set to safe mode before connecting. Insert each LC connector firmly into the corresponding LC port on devices or patch panels until it clicks. Route the cable to avoid tight bends and mechanical strain; maintain the minimum bend radius specified by the equipment manufacturer. After installation, perform link verification with appropriate fiber test tools to confirm signal loss and continuity.

Recommendations

Use this OM1 multimode LC duplex patch cable for short-range indoor links. Avoid outdoor exposure and direct sunlight; keep the cable within racks and conduits suited for LSZH cables. For longer distances or higher bandwidth requirements consider multimode OM3/OM4 or singlemode alternatives.