ACT ivoor 30 meter U/UTP CAT6 patchkabel met RJ45-stekkers

The ACT Ivory 30 meter U/UTP CAT6 patch cable with RJ45 connectors is a single-pair network patch lead designed for structured cabling in home and office networks. It delivers Category 6 performance for Gigabit Ethernet and other high-speed network protocols, while the U/UTP construction helps reduce external electromagnetic interference. The cable is finished in an ivory colour and terminated with RJ45 plugs featuring gold-plated contacts to maintain reliable signal transmission over its 30 m length.

Advantages

This CAT6 patch cable provides consistent data throughput suitable for Gigabit Ethernet and many standard LAN applications. The U/UTP (unshielded twisted pair with an overall braid) design lowers susceptibility to noise from nearby electrical equipment. Gold-plated RJ45 contacts improve contact reliability and resist corrosion, while the 30 m length allows flexible placement of devices without additional extension hardware. The ivory outer sheath offers a discreet aesthetic for visible installations.

Suitable for

• Connecting desktop PCs, laptops, printers and networked peripherals to switches or routers
• Wired Ethernet connections for smart TVs, media players and set-top boxes
• Small office and home network patching between wall outlets and networking equipment
• Temporary or permanent cabling where a 30 m reach is required

Key specifications

• Category: CAT6
• Shielding: U/UTP (overall shield with unshielded twisted pairs)
• Length: 30 m
• Connectors: RJ45 to RJ45
• Contact plating: gold-plated contacts
• Colour: ivory
• Application: Gigabit Ethernet, LAN connectivity

How to use

Route the ACT CAT6 patch cable between the two network devices you intend to connect, avoiding tight bends and sharp kinks to preserve cable performance. Insert each RJ45 connector firmly into the corresponding network port until the latch clicks. For wall-mounted or concealed runs, secure the cable with clips or cable ties at reasonable intervals, maintaining bend radius recommendations and avoiding proximity to high-voltage power lines. Test the connection with a network tester or by verifying link/activity LEDs on the connected devices.

Recommendations

For best performance, avoid bundling the cable tightly with mains power cables and maintain proper bend radius. Use the cable within temperature and installation conditions typical for indoor networking. If you require PoE (Power over Ethernet) or very long permanent runs beyond 30 m, verify power and signal requirements and consider using switches or midspan injectors as needed.