ACT Powercord Netkabel CEE 7/7 stekker (haaks) - C19 geel 1,2 m

The ACT Powercord CEE 7/7 male angled ACT AK5180 1.2m is a mains connection cable designed for 230 V, 16 A applications. It combines a CEE 7/7 angled male plug with a C19 coupler on the opposite end, providing a compact, durable solution for powering equipment that uses a C19 inlet. The cable length of 1.2 m offers a balance between reach and neat cabling in rack, office, and industrial environments. The bright yellow outer jacket increases visibility and helps identify the cable within cable runs.

Advantages

The angled CEE 7/7 plug reduces strain at the wall socket and allows for installation where space behind the socket is limited. A C19 coupler provides compatibility with high-current equipment such as servers, PDUs, and professional power supplies. The 16 A rating and 230 V specification match common mains standards in many regions, supporting safe operation under expected loads. The 1.2 m length minimizes excess cabling while giving sufficient reach for most setups, and the yellow colour aids rapid identification and organization.

Suitable for

• Connecting servers, rack equipment, and PDUs with C19 inlets
• Powering professional power supplies and high-current appliances
• Short to medium reach cabling in data center and office environments
• Temporary power setups and service carts where visibility is important

Key specifications

• Cable length: 1.2 m
• Input voltage: 230 V
• Current rating: 16 A
• Connector 1: CEE 7/7 angled male
• Connector 2: C19 coupler
• Outer colour: Yellow

How to use

Inspect the cable and connectors for visible damage before use. Insert the angled CEE 7/7 plug into a compatible 230 V mains outlet, ensuring the plug is fully seated and the orientation allows proper strain relief. Connect the C19 coupler to the device inlet until it is securely engaged. Avoid routing the cable across sharp edges or heat sources and do not exceed the 16 A current rating. When disconnecting, grasp the connector bodies rather than pulling on the cable jacket to prevent damage.

Recommendations

For safe and reliable operation, use this cable only with equipment rated for 230 V and up to 16 A. Regularly check connectors for wear, secure connections in rack installations to prevent accidental disconnection, and store the cable coiled without tight bends. Replace the cable if the outer jacket or connector housings are damaged.