Adapter G1/4 inch buitendraad naar G1/4 inch binnendraad, BitsPower Touchaqua, recht 40 mm, zwart (2-pack)

Straight BitsPower Touchaqua adapter for liquid-cooling fittings that converts G1/4" male threads to G1/4" female threads. The adapter is 40 mm long and supplied as a pack of two in black finish. It is designed to provide a compact, straight-threaded connection where a change of thread gender is required in PC water-cooling loops, enabling extension or rerouting of fittings between tubing, radiators, pumps and water blocks while keeping the connection inline.

Advantages

The adapter offers a standardized G1/4" interface compatible with most PC water-cooling fittings, ensuring interchangeability and predictable sealing when used with appropriate sealing washers or tape. Its straight 40 mm form factor keeps tubing runs compact and aligned, reducing strain on adjacent components and simplifying loop layout. Supplied as a two-piece pack, it provides spare parts or a matched pair for symmetrical installations. The black finish minimizes visual contrast in dark-themed builds and resists minor cosmetic wear during installation.

Suitable for

• Converting male-to-female thread gender in PC liquid-cooling loops
• Extending fittings to bridge gaps between components (radiator, pump, reservoir, block)
• Replacing damaged or mismatched thread fittings without changing components
• Compact, straight inline connections where angled fittings are not required

Key specifications

• Thread standard: G1/4" male to G1/4" female conversion
• Orientation: straight inline adapter
• Length: 40 mm
• Finish: black
• Pack quantity: 2 pieces

How to use

Ensure all components are depressurized and the loop is drained before installing the adapter. Hand-start the adapter into the mating thread to avoid cross-threading, then tighten to a secure fit using appropriate tools if required; avoid over-torquing. Use compatible sealing washers or PTFE tape on threaded interfaces as recommended for your fittings to ensure a leak-free connection. Install the adapter inline between the existing male and female fittings, verifying alignment so tubing and neighboring components are not under strain. After installation, perform a controlled leak test before powering the system.

Recommendations

For reliable sealing, use the adapter with fittings rated for G1/4" threads and inspect O-rings or washers for wear before reuse. When integrating into a new or modified loop, perform a minimum 24-hour leak test with the system powered off and a paper towel or absorbent material placed around connections to detect any slow leaks.