Adapter IEC-bus naar F-bus ShiverPeaks 85324-SET10, 10-delige set

The ShiverPeaks adapter converts an IEC female socket to an F female socket, supplied in a set of 10 identical passive adapters. It provides a compact mechanical connection to link coaxial F-type equipment such as antenna, cable TV or satellite leads to devices or cables that use IEC female connectors. The adapter is intended for basic signal routing and compatibility bridging where a passive mechanical interface is sufficient.

Advantages

This adapter set offers a simple, space-saving solution for converting between IEC and F female connectors without the need for active electronics. Supplied as a set of 10 pieces, it supports batch installations, mass replacements and spare-part provisioning. The passive design requires no power and introduces minimal change to installation workflow when integrating F-type coaxial devices with IEC-based ports.

Suitable for

• Connecting antenna or cable TV coaxial leads to devices with IEC female sockets
• Temporary or permanent signal bridging between IEC and F-type connections
• Batch installations, service fleets, and stock for installers or technicians
• Replacing worn or missing adapters in domestic or small commercial setups

Key specifications

• Type: passive mechanical adapter converting IEC female to F female
• Quantity: set of 10 identical adapters
• Compatibility: fits standard IEC and F-type coaxial connectors
• Use case: signal routing and mechanical interface only (no amplification)
• Form factor: compact inline adapter for coaxial cabling

How to use

To use the adapter, align the F female end with the F-type coaxial plug and insert until it seats securely, then attach the IEC female end to the corresponding IEC male connector on the device or cable. Ensure connections are tightened to avoid loose contact; do not apply excessive torque. These adapters are intended for coaxial signal paths and should be used where a passive mechanical conversion is acceptable. Inspect connections for corrosion or damage before installation and replace any adapter that shows wear.

Recommendations

For best results, use the adapters in dry, indoor environments and avoid exposure to prolonged moisture or salt air. If maintaining signal quality is critical, verify signal levels after installation and consider using a direct cable with matching connectors or a professionally installed feed if passive conversion introduces measurable loss.