Actieve optische kabel (AOC) CBO voor Alcatel‑Lucent SFP 10G 15m

BlueOptics Active Optical Cable (AOC) CBO for Alcatel‑Lucent SFP 10G 15m is a factory-terminated fiber link that delivers 10 Gigabit Ethernet connectivity over a 15-meter duplex optical cable. The cable assembly is compatible with Alcatel‑Lucent SFP ports and is intended for short-reach, high-throughput interconnects between servers, switches and storage devices. By replacing copper twinax or longer electrical runs, this AOC reduces signal loss and electromagnetic interference while preserving the form factor and hot-pluggable convenience of SFP modules.

Advantages

The Active Optical Cable offers low latency and stable 10G performance across the full 15 m span, with integrated transceivers that eliminate separate SFP modules and fiber patching. Its optical transmission minimizes EMI and crosstalk in dense rack environments and enables longer effective reach compared with direct-attach copper. The factory-terminated construction simplifies installation and reduces the need for field polishing or complex connector termination. Compact, lightweight construction improves routing and airflow inside racks.

Suitable for

• 10 Gigabit interconnects between switches and top-of-rack or leaf switches
• Server-to-switch and server-to-storage connections in data centers
• High-density rack environments where electromagnetic interference must be minimized
• Short to medium reach links where SFP form-factor compatibility is required

Key specifications

• Data rate: 10 Gigabit Ethernet
• Connector/form-factor: SFP-compatible duplex optical interfaces integrated into the cable ends
• Maximum length: 15 meters (fixed factory-terminated)
• Transmission medium: Duplex multimode or singlemode active optical assembly (integrated optics)
• Typical latency: low, suitable for latency-sensitive applications
• EMI immunity: optical transmission reduces electromagnetic interference compared with copper
• Operating environment: designed for data center and enterprise networking use

How to use

Install the cable by inserting each SFP-compatible end into the corresponding Alcatel‑Lucent SFP port until it latches; no separate transceiver or fiber patch cords are required. Ensure devices are powered off or follow hot-swap procedures recommended by the equipment vendor if inserting into live systems. Verify link status and speed on both endpoints and check switch or server logs for any compatibility messages. Route the cable to avoid sharp bends and maintain the manufacturer’s minimum bend radius to preserve optical performance.

Recommendations

For reliable operation, use the AOC in short-reach data center links up to 15 m, avoid exceeding specified bend radius, and confirm compatibility with the Alcatel‑Lucent SFP port firmware or compatibility lists. Keep connectors and module latches free of dust, and power-cycle endpoints if link negotiation does not occur immediately after installation.