Glasvezel SFP+-transceiver CBO 407-BBVJ-BO 10000 Mbit/s LC

The BlueOptics fiber optic SFP+ transceiver CBO 407-BBVJ-BO supports 10,000 Mbit/s (10 Gbit/s) data transmission over multimode or singlemode fiber with an LC connector. The compact SFP+ form factor is compatible with SFP+ slots on switches, routers and servers, enabling straightforward installation or replacement in environments where 10 Gbps links are required. The module is designed for short- and mid-range fiber connections and provides a standardized interface for high-speed uplinks and server connectivity.

Advantages

This SFP+ transceiver delivers 10 Gbit/s performance in a small, hot-pluggable module that reduces rack-space constraints and simplifies upgrades. The LC connector provides a common, industry-standard physical interface for fiber cabling. The module’s form factor and electrical/optical characteristics enable interoperability with compatible network devices, allowing quick swaps and minimal downtime during maintenance or scaling of network infrastructure.

Suitable for

• 10 Gbit/s uplinks between switches and core routers
• Server-to-switch high-speed connectivity in data centers
• Short- and mid-range fiber links within campus and enterprise networks
• Network equipment upgrades where SFP+ LC interfaces are required

Key specifications

• Data rate: 10,000 Mbit/s (10 Gbit/s)
• Form factor: SFP+ hot-pluggable module
• Connector type: LC duplex
• Application: short- and mid-range fiber optic links
• Compatible with standard SFP+ ports on switches, routers and servers

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on the network device until it latches. Connect the LC duplex fiber cable to the transceiver’s LC connector, ensuring correct polarity and clean fiber endfaces. After connecting, verify link status and configure the network interface according to the device operating system or switch management interface. For replacement, power down the device if required by the manufacturer, remove the existing module, and install the new transceiver following the same steps.

Recommendations

Ensure fiber connectors are clean before mating to avoid signal loss. Use LC-compatible duplex fiber cables rated for the intended distance and fiber type. Verify compatibility with the network device vendor’s supported transceivers list to prevent interoperability issues. Follow electrostatic discharge (ESD) precautions when handling the module and store unused transceivers with protective caps fitted.