Glasvezel-SFP-transceiver CBO SFP-1G-LX BO05C13610D — 1 Gbps, LX

CBO SFP-1G-LX BO05C13610D is a BlueOptics fiber optic SFP transceiver module designed to provide reliable 1 Gbps single‑mode fiber connectivity using LX optics. The module fits standard SFP ports on switches, routers and media converters to establish uplinks and long‑distance links over single‑mode fiber. It is intended for network upgrades, campus backbones and ISP access links where a stable 1 Gbps fiber connection with LX wavelength characteristics is required.

Advantages

The transceiver supports a 1 Gbps data rate and LX optics, delivering long‑reach single‑mode transmission with low power consumption and compact SFP form factor. Hot‑pluggable design allows insertion and removal without powering down equipment, and compatibility with standard SFP interfaces simplifies integration into existing network hardware. Its BlueOptics design focuses on predictable optical performance and interoperability with a wide range of networking devices.

Suitable for

• 1 Gbps uplink connections between switches
• Long‑distance links over single‑mode fiber in campus networks
• ISP edge and access links requiring LX optics
• Replacement or upgrade of SFP fiber ports on routers and media converters

Key specifications

• Data rate: 1 Gbps (Gigabit Ethernet)
• Optical type: LX for single‑mode fiber long‑reach transmission
• Form factor: SFP (small form‑factor pluggable), hot‑pluggable
• Typical reach: suitable for long‑distance single‑mode links (LX class)
• Connector type: standard fiber LC connector compatibility
• Power consumption: low power operation compatible with SFP slot power budgets

How to use

Install the CBO SFP-1G-LX module into an available SFP port on a switch, router or media converter until it clicks into place. Connect single‑mode fiber terminated with LC connectors to the module's optical port, observing correct transmit/receive orientation. Ensure the host device is configured for 1 Gbps fiber operation if necessary and verify link status through the device management interface. The module is hot‑pluggable, so it can be inserted or removed while equipment remains powered; follow your equipment vendor's guidelines for hot swapping.

Recommendations

Use clean, certified single‑mode fiber and LC connectors to maintain signal integrity. Verify transceiver compatibility with the host device's SFP port and review link settings (speed/duplex) in the network equipment to ensure stable operation. For long spans, perform optical power and link tests to confirm margin and attenuation are within acceptable ranges.