BlueOptics SFP-2-CM-BO netwerk-transceivermodule glasvezel 155 Mbit/s 1310 nm

The BlueOptics SFP-2-CM-BO is a fiber optic SFP transceiver module designed for data rates up to 155 Mbit/s. Operating at a wavelength of 1310 nm, the module is enclosed in a steel-coloured metal housing and requires a 3.3 V supply. It implements the SFP interface and is suitable for single-mode and multimode fiber links where an SFP 1310 nm transceiver is appropriate. The compact, lightweight construction (approx. 3 g) supports integration into switches, routers and other network devices that accept SFP modules.

Advantages

The module offers standardized SFP connectivity and supports optical transmission at 1310 nm for distances typical to 100BASE-FX and similar protocols. Its metal housing provides mechanical durability and EMI shielding. Low weight and SFP form factor allow straightforward hot-pluggable replacement or expansion of network ports. The unit is compatible with common networking equipment that follows MSA SFP standards and is designed for continuous optical link operation at up to 155 Mbit/s.

Suitable for

Key specifications

How to use

Power off or follow hot-swap procedures specified by your network hardware, then insert the SFP module into an empty SFP slot until it clicks into place. Connect LC duplex fiber patch cords with correct polarity to the module and the remote transceiver or patch panel. Ensure connected equipment is configured for the intended protocol and data rate (up to 155 Mbit/s). If supported by your hardware, enable or verify Digital Diagnostic Monitoring (DDM/DOM) in the host device to monitor optical parameters.

Recommendations

Use high-quality LC duplex fiber patch cords and verify fiber type and connector polarity prior to operation. Confirm host device compatibility with SFP 1310 nm modules and, when available, use DDM/DOM functions to monitor link status and optical parameters for reliable maintenance.