Glasvezel-transceivermodule BlueOptics 10G-SFP-LR-SA-BO SFP+ 10000 m

The BlueOptics 10G-SFP-LR-SA-BO SFP+ fiber optic transceiver module provides 10 Gbps optical data transmission over single-mode fiber for distances up to 10,000 m. Designed in an aluminium housing, this SFP+ transceiver implements the 10GBASE-LR physical layer and uses an LC duplex interface for transmit and receive on separate fibers. It is compatible with MSA-compliant SFP+ ports and intended for integration into network switches, routers and storage systems that accept standard 10GBASE-LR SFP+ modules.

Advantages

The module offers long-reach single-mode connectivity with 10 Gbps throughput in a compact SFP+ form factor and a lightweight aluminium housing. It supports simultaneous transmit and receive on LC duplex connectors and is built to industry mechanical and electrical standards for interoperability. The transceiver is suitable for deployments that require low electromagnetic susceptibility and stable optical performance over extended distances.

Suitable for

• Connecting 10 Gbps links over single-mode fiber between data centre switches and aggregation points
• Long-distance uplinks and campus backbone links up to 10 km
• High-speed connections for storage systems, routers and load balancers
• Replacing or expanding SFP+ ports in MSA-compliant network equipment

Key specifications

• Interface type: SFP+ (LC duplex)
• Data rate: 10 Gbps (10GBASE-LR)
• Transmission distance: up to 10,000 m over single-mode fiber
• Wavelength: 1310 nm for transmitter and receiver
• Housing material and colour: aluminium
• Weight: 0.02 kg

How to use

Install the transceiver into an empty MSA-compliant SFP+ slot following the host device manufacturer’s hot-swap or installation procedure. Connect an LC duplex single-mode patch cable to the module, observing correct transmit/receive orientation. Verify link status and optics diagnostics via the host device management interface. Ensure the receiving device is configured for a 10GBASE-LR SFP+ connection and that firmware or driver requirements of the network equipment are met for third-party transceivers.

Recommendations

Use single-mode fiber with appropriate LC duplex patch cords and minimize tight bends in the fiber run. Confirm DDM/DOM support on the host device to enable real-time monitoring of optical parameters where available. Follow ESD precautions and the equipment vendor’s guidelines during module installation and removal.