Kabel EcoFlow LMC4-XT60I-2,5M voor zonnepanelen, XT60i-aansluiting, 2,5 m, zwart/rood

EcoFlow LMC4-XT60I-2.5M is a 2.5 m DC connection cable designed to connect compatible EcoFlow solar panels directly to EcoFlow DELTA 2 and other compatible EcoFlow power stations via XT60i connectors. The cable uses clearly marked black and red conductors to maintain correct polarity and provides a weather-resistant, fixed-length link for portable and temporary on-site solar charging without the need for adapters.

Advantages

The cable is engineered for secure electrical contact with XT60i interfaces and stable current transfer over its 2.5 m length. Its molded connector ends and insulated conductors reduce the risk of accidental disconnection and protect against typical outdoor stressors during temporary installations. Being manufacturer-matched, the cable simplifies setup and avoids improvised wiring between EcoFlow solar panels and EcoFlow power stations.

Suitable for

• Direct solar charging of EcoFlow DELTA 2 and other compatible EcoFlow power stations from EcoFlow solar panels
• Portable power setups for camping, RVs and outdoor activities
• Emergency backup charging where on-site solar input is required
• Off-grid or remote installations with short cable runs

When it may not be suitable

This cable is intended specifically for use with compatible EcoFlow XT60i-equipped solar panels and EcoFlow solar input ports. It may not be suitable if your panel or power station uses a different connector standard or requires a longer cable run than 2.5 m. Do not use the cable where a different voltage/current rating is required than that supported by EcoFlow solar inputs.

Key specifications

• Cable length: 2.5 m
• Connector type: XT60i molded connectors for DC solar input
• Conductors: black and red insulated DC conductors for correct polarity
• Construction: insulated DC cable with molded connector housings
• Intended environment: outdoor/portable use with weather-resistant connector design

How to use

Connect the XT60i end of the cable to the compatible EcoFlow solar panel output and the other XT60i end to the DELTA 2 or compatible EcoFlow power station solar input, ensuring connectors are fully seated and locked. Route the cable to avoid sharp bends and reduce strain on connectors during use. Place panels for optimal sunlight exposure and monitor the power station display or companion app to confirm solar input and charging status.

What to consider before purchase

• Check that both the solar panel and power station support XT60i connectors
• Confirm 2.5 m cable length is sufficient for your setup
• Verify that the EcoFlow solar input voltage/current specifications match your panel output
• Consider storage and protection from prolonged exposure to water and UV when used outdoors

Recommendations

Use this cable only with compatible EcoFlow solar panels and EcoFlow power stations. Inspect connectors and insulation before each use and avoid leaving exposed connectors in standing water. Store the cable indoors when not in use to prolong service life and replace it if the insulation or connector housings show significant wear.