Kabelset 1 m 35 mm² voor IVT SW-serie omvormers 2000 W

Cable set 1 m 35 mm² for IVT SW series inverter 2000 W is a heavy-gauge connection kit designed to link an IVT SW series 2000 W inverter to a battery bank or power distribution point. The 1 metre length with 35 mm² conductor cross-section provides the current-carrying capacity needed for medium-power installations while minimizing voltage drop over the short run. The cable set is intended for reliable DC connection in solar, backup power and off-grid systems where a compact, robust link is required.

Advantages

The cable set combines a short cable length with a large conductor area to reduce power loss and heat generation in the connection. Its 35 mm² cross-section supports higher continuous currents compared to thinner cables, ensuring stable operation of a 2000 W inverter under normal load. The design simplifies installation near the inverter or battery thanks to the 1 m length, and the heavier gauge increases mechanical durability and lower resistance for safer operation.

Suitable for

Key specifications

How to use

Route the cable set between the inverter DC terminals and the battery positive and negative posts, observing correct polarity. Ensure all connections are clean, tight and protected with appropriate terminal lugs or connectors compatible with the inverter and battery posts. Secure the cable to avoid strain or chafing and keep it away from sharp edges and high-temperature surfaces. Verify system voltage and follow the inverter manufacturer’s recommended fusing and protection requirements before energizing the system.

Recommendations

Use this 1 m 35 mm² cable set for short-distance DC connections only; for longer runs calculate voltage drop and select larger conductor sizes if necessary. Install appropriate DC fuses or circuit breakers close to the battery, and follow local electrical codes and the inverter manufacturer’s instructions for safe operation.