Kabeltrekstang c.k tools MightyRod PRO 1 m, 6 mm, fosforescerend

The c.k tools MightyRod PRO cable pulling rod is a 1 m long, 6 mm diameter rod with a phosphorescent finish designed for routing and guiding cables in conduits and confined spaces. The tool combines sufficient rigidity for pushing with enough flexibility to negotiate bends and offsets, and its phosphorescent coating improves visibility in low-light environments. Intended for electricians and installers, this rod supports efficient single-operator cable installation in residential, commercial and light industrial settings.

Advantages

The rod's 6 mm diameter and 1 m length deliver a balance between pushability and maneuverability, allowing controlled advancement through tight runs. The phosphorescent finish enhances visibility in dark shafts and voids without adding electronic illumination. Construction and material selection provide durability for repeated use while maintaining a slim profile suitable for narrow conduits. The product's design minimizes the need for a second operator by enabling one-person feeding and guiding of cables.

Suitable for

Key specifications

How to use

Insert the c.k tools MightyRod PRO into the conduit or access point and gently push while guiding around bends with controlled pressure. If resistance is met, withdraw slightly and re-approach the bend to avoid buckling. Once the rod reaches the outlet or pull point, attach the cable using an appropriate connector, tape or swivel coupling, and pull the rod back while feeding the cable through the conduit. Inspect the rod and phosphorescent finish after use and store in a dry place to maintain visibility properties.

Recommendations

Use the rod for runs compatible with a 6 mm diameter profile and avoid excessive force on sharp bends. For long or complex routes, consider using additional rods or a rod system to reach required lengths. Clean the rod after use and check for damage before each job; replace if permanent deformation or compromise of the coating is present.