Netwerkkabel EFB Elektronik K8104GN.7,5 RJ-45 Cat6 7,5 m groen

The EFB Elektronik K8104GN.7,5 is a 7.5 m networking cable designed to meet Cat6 performance requirements. It uses U/UTP construction and terminates in RJ-45 connectors on both ends with gold-plated contacts to support reliable signal transmission. Rated for data transfer rates up to 5000 Mbit/s, this green cable is suitable for connecting computers, network switches and other Ethernet-enabled devices where stable, high-speed wired connections are needed.

Advantages

The cable's Cat6 specification provides improved bandwidth and reduced crosstalk compared with lower-category cables. U/UTP shielding helps maintain signal integrity in typical office and home environments. Gold-plated RJ-45 connectors promote consistent contact and corrosion resistance, and the 7.5 m length offers flexibility for routing between equipment without excessive slack.

Suitable for

• Wired Ethernet connections between PCs, laptops and routers
• Connecting network switches and patch panels in small offices
• Home network setups for streaming, gaming and file transfers
• Temporary or permanent cabling where a 7.5 m run is required

Key specifications

• Cable length: 7.5 m
• Standard: Cat6
• Shielding: U/UTP
• Connectors: RJ-45 to RJ-45
• Connector plating: Gold-plated contacts
• Maximum data rate: 5000 Mbit/s
• Colour: Green

How to use

Plug one RJ-45 connector into the Ethernet port of your computer, router, switch or other network device and insert the other connector into the corresponding port on the remote device. Ensure connectors click into place to confirm a secure connection. Route the cable to avoid tight bends, pinching or areas of heavy foot traffic; avoid running the cable alongside high-power electrical lines to reduce potential interference. For wall-mounted or rack installations, use appropriate cable management accessories to secure the run and prevent strain on the connectors.

Recommendations

For best performance, use the cable within the Cat6 standard operating environment and inspect connectors before use. If connecting equipment that supports higher-category cabling or shielding requirements, confirm compatibility with existing infrastructure. Replace the cable if connectors are damaged or if data performance degrades.