Netwerkkabel Helos Patchkabel - RJ-45 (M) naar RJ-45 (M) Cat 6 5m blauw

The Helos Patch Cable is a Cat 6 network cable with RJ-45 male connectors on both ends and a length of 1 meter. Designed for typical home and office networking, the cable supports gigabit Ethernet speeds and is finished in black. Its construction provides consistent signal transmission and reliable connectivity between routers, switches, modems, network interface cards and other Ethernet-enabled devices.

Advantages

This Cat 6 patch cable delivers stable data transfer up to 1 Gbps and meets performance expectations for standard Ethernet environments. The RJ-45 connectors ensure secure, tool-free connections and the one-meter length is convenient for close-proximity device setups. The cable's outer jacket and connector housings are designed for everyday handling, offering resistance to bending and regular plugging cycles.

Suitable for

• Connecting a computer or laptop to a router or switch
• Linking a network switch to a modem or gateway
• Patch panel to network device connections in small racks or desks
• Temporary or permanent workstation cable runs where 1 m length is sufficient

Key specifications

• Category: Cat 6 (suitable for gigabit Ethernet)
• Connector type: RJ-45 Male to RJ-45 Male
• Length: 1 meter
• Color: Black
• Typical data rate supported: up to 1 Gbps over standard Ethernet
• Cable use: patching between network equipment and endpoints

How to use

Connect one RJ-45 end to the Ethernet port of your device and the other end to the corresponding port on a router, switch or modem. Ensure connectors click into place to confirm a secure mechanical and electrical connection. For optimal performance, avoid tight bends near connector ends and keep the cable clear of high-interference power sources. If installing in a structured cabling system, route the cable along existing trays or conduits and avoid excessive tension during placement.

Recommendations

Use this Cat 6 patch cable for short interconnects where one-meter length is appropriate. For longer runs or environments with high electromagnetic interference, consider shielded cables or higher-category cabling as required. Inspect connectors periodically for wear and replace the cable if the connector latch or jacket shows damage.