Netwerkkabel LANBERG LCU6-10CC-0305-Y U/UTP Cat6 305 m geel, 23 AWG, 250 MHz

The Lanberg LCU6-10CC-0305-Y is a 305 m networking cable in bright yellow designed for structured cabling installations. It is built to the U/UTP (unshielded twisted pair) standard and supports data transmission up to 1000 Mbit/s, making it suitable for typical Ethernet applications where a visible, single-run cable is required. The cable is supplied as a bulk reel without connectors, allowing termination to RJ45 plugs or keystone jacks at installation sites.

Advantages

This U/UTP cable combines a long 305 m length with a high-visibility yellow jacket that simplifies identification in wiring closets and cable trays. Its construction follows the Category 6 family layout to deliver reliable performance for Gigabit Ethernet lines up to the supported data rate. Supplied without pre-attached connectors, the cable provides flexibility for custom terminations and on-site finishing by network installers.

Suitable for

Key specifications

How to use

Measure and route the required length from the reel through cable trays, conduits, or along planned pathways to endpoints. Cut and prepare individual pairs according to the chosen termination standard, then attach RJ45 plugs, punch down to patch panels, or terminate into keystone jacks following best practices for pair untwisting and cable management. Test each run with a cable tester to verify continuity and correct pair mapping before commissioning the network.

Recommendations

For optimal performance, avoid sharp bends and excessive tension while pulling the cable, maintain appropriate separation from power lines and sources of electromagnetic interference, and adhere to recommended maximum run lengths for Ethernet. Use appropriate strain relief at termination points and perform post-installation testing to confirm link quality.