Netwerkkabel LogiLink 1,5 m Cat.6 RJ-45 S/FTP oranje

Patch Cable Cat.6 S/FTP PIMF PrimeLine orange 1.50m LogiLink is a 1.5 m network patch cable with RJ‑45 connectors at both ends. The cable uses S/FTP (shielded foiled twisted pair with overall braid) construction and PIMF (pair in metal foil) shielding to reduce electromagnetic interference. It features AWG 27/7 stranded bare copper conductors and an LSZH (low smoke zero halogen) jacket. The cable meets ISO/IEC 11801, EN50288 and TIA/EIA 568‑B.2‑1 standards.

Advantages

The S/FTP PIMF design provides improved protection against crosstalk and external interference, supporting reliable Gigabit Ethernet performance. AWG 27/7 stranded bare copper conductors offer good flexibility and signal conductivity while the LSZH jacket reduces smoke and toxic gas emissions in case of fire. The bright orange colour simplifies cable identification in patch panels and structured cabling installations.

Suitable for

• Office and home network patching
• Connections between switches, routers and patch panels
• Structured cabling requiring shielded Cat6 performance
• Environments where low‑smoke, low‑halogen materials are preferred

Key specifications

• Length: 1.5 m
• Connector: RJ‑45 to RJ‑45
• Cable type: Cat.6 S/FTP (PIMF)
• Conductor: AWG 27/7 bare copper
• Jacket: LSZH (low smoke zero halogen)
• Colour: Orange
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568‑B.2‑1
• Weight: 50 g

How to use

Plug each RJ‑45 connector into the corresponding network ports on your devices (for example switch, router, patch panel or network interface). Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and excessive tension to maintain signal integrity. For shielded installations, attach cable shields to grounded panels or connectors according to your site grounding practice.

Recommendations

Use this Cat.6 S/FTP patch cable for Gigabit Ethernet and other high‑speed network links where reduced electromagnetic interference and low‑smoke jacket material are required. Avoid running the cable parallel to high‑voltage power lines to minimise interference.