Netwerkkabel LOGON SSTP Cat6a RJ-45 RJ-45 3 m rood

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 3 m in red, is a shielded Ethernet cable designed for high-speed data transmission and reliable connection in home and office networks. It uses Cat6a construction with SSTP (shielded, screened twisted pair) combining foil and full braid shielding to reduce interference and support demanding network environments.

Advantages

This cable provides balanced twisted pairs (4 x 2 x AWG 26/7) with 100 Ohm impedance, supports Cat6a bandwidths up to 500 MHz, and features two shielded RJ45 male connectors. The moulded boot includes kink protection and strain relief for improved connector durability, and the wiring follows a 1:1 EIA/TIA 568B pinout for straightforward, compatible connections.

Suitable for

• Gigabit and 10 Gigabit Ethernet links in office or data center patching
• High-speed connections between switches, routers and workstations
• Shielded installations where EMI/RFI reduction is required
• Structured cabling and patch panels using RJ-45 terminations

Key specifications

• Length: 3 m
• Cable type: SSTP Cat6a (foil + full braid)
• Pairs: 4 x 2 x AWG 26/7, twisted pair
• Impedance: 100 Ohm
• Connectors: 2 x shielded RJ45 male
• Wiring: 1:1 EIA/TIA 568B
• Colour: Red

How to use

Connect one shielded RJ45 plug to your network device (switch, router, NIC) and the other plug to the corresponding port on the other device. Ensure both ends are fully inserted until the connector latch clicks. Route the cable to avoid sharp bends and excessive tension; the moulded boot with strain relief helps prevent connector damage but avoid stretching or twisting the cable.

Recommendations

For optimal performance in shielded environments, connect the cable to grounded equipment or shielded patch panels so the SSTP shielding can be effective. Avoid running the cable parallel to strong power lines for long distances to minimise interference.