Netwerkkabel Microconnect ECO-MC-UTP6A05W Cat6a 5m wit

The Microconnect ECO‑MC‑UTP6A05W Cat6a 5m network cable is a responsibly produced patch lead made with recycled materials. Designed for reliable high‑speed data transmission, this 5‑metre U/UTP cable supports Gigabit and higher networking requirements for home and office environments while featuring durable construction for long service life.

Advantages

The cable jacket and connector housings are made from post‑consumer recycled rPVC certified to the Global Recycled Standard, combining environmental responsibility with robust physical protection. It meets Fluke CAT6A channel link test requirements, is PoE+ ready for powering compatible devices, uses LSZH (Low Smoke Zero Halogen) materials for reduced toxic emissions in case of fire, and includes a snagless hood plus length marking on the boot for easier installation and identification.

Suitable for

• Connecting PCs, switches and routers in home networks
• Office workstations and local area networks
• PoE/PoE+ powered devices such as VoIP phones and access points
• Patch panels and structured cabling installations

Key specifications

• Standard: Cat6a (UTP)
• Length: 5 m
• Conductor type: U/UTP (unshielded)
• Materials: Jacket and housing contain post‑consumer recycled rPVC (Global Recycled Standard certified)
• Fire safety: LSZH (Low Smoke Zero Halogen)
• Testing: Fluke CAT6A channel link pass
• PoE support: PoE+
• Features: Snagless hood, length marking on boot
• Brand / MPN / EAN: MicroConnect / ECO-MC-UTP6A05W / 5715063597644

How to use

Plug each RJ45 connector into the corresponding network port on your devices (switch, router, PC or patch panel). Ensure connectors are fully seated and the cable is routed without sharp bends or excessive tension. For structured cabling, terminate and test links according to standard site procedures and verify performance with a suitable tester that supports Cat6a channel testing.

Recommendations

Use the cable within its specified length and environmental ratings; avoid running it beside high‑power electrical cables to reduce interference. For permanent installations, test each channel after termination and label both ends using the length marking for easier maintenance.