ACT bruine 5 meter U/UTP CAT6A patchkabel met RJ45-stekkers

ACT Brown 5 meter U/UTP CAT6A patch cable with RJ45 connectors is built with full copper conductors and meets ANSI/TIA568-C2-1 performance requirements. The cable supports CAT6A data rates and 10/100/1000Base-T(X) cabling technology, and its U/UTP construction reduces external interference while providing reliable connectivity over a 5 m run. The brown jacket identifies the cable visually without affecting electrical performance.

Advantages

The cable uses full copper conductors and gold-plated RJ45 contacts to ensure stable signal transmission and low contact resistance. Compliance with ANSI/TIA568-C2-1 and CPR Euroclass Eca provides predictable performance and safety characteristics. U/UTP CAT6A construction offers improved immunity to electromagnetic interference compared with lower-category unshielded alternatives, and the 5 m length suits short patching runs in patch panels, switches and wall outlets.

Suitable for

• Short connections between switches, patch panels and network devices
• Ethernet networks up to CAT6A speeds (10/100/1000Base-T(X) and compatible higher rates within CAT6A)
• PoE (Power over Ethernet) deployments that require full copper conductors
• Home and office structured cabling where a brown cable is preferred for identification

Key specifications

• Length: 5 m
• Category: CAT6A, U/UTP
• Conductors: full copper
• Connectors: RJ45 — gold-plated contacts
• Cabling technology: 10/100/1000Base-T(X)
• Colour: Brown
• MPN: IB4405
• EAN: 8716065285604
• CPR Euroclass: Eca

How to use

Insert each RJ45 connector into the corresponding network port until the latch clicks to secure the connection. Use the 5 m length for patching between racks, from patch panel to switch, or from wall outlet to device. Ensure cable routing avoids tight bends and sharp edges; maintain the manufacturer’s minimum bend radius and do not subject the cable to excessive pulling force during installation.

Recommendations

For PoE applications and maximum reliability, always use ACT patch cables with full copper conductors and avoid mixing with cables that use copper-clad aluminum (CCA). Keep cable runs within recommended distances for Ethernet and follow local installation standards for cable management and fire safety.