ACT rood 20 meter U/UTP CAT6A patchkabel rastnasenfrei met RJ45-stekkers

The ACT Red 20 meter U/UTP CAT6A patch cable with RJ45 connectors is a 20 m unshielded cable designed for high-speed network connections. It supports data transfer rates up to 10 Gbps and features snagless RJ45 plugs with gold-plated contacts for reliable signal transmission. The cable uses full copper AWG#24 conductors and comes in a red jacket for easy identification in routing and patch panels.

Advantages

All cables are 100% tested and verified to meet ACT specifications by an independent third-party certification institute. The full copper AWG#24 conductors and 50 µin gold-plated RJ45 contacts reduce signal loss and improve durability. A five-year warranty covers manufacturing defects.

Suitable for

• Connecting network switches, routers and patch panels in offices
• High-speed data transfer between PCs, NAS devices and servers
• Home networking and media streaming setups
• Structured cabling where colour-coding is required

Key specifications

• Cable type: U/UTP (unshielded twisted pair)
• Category: CAT6A
• Length: 20 m
• Conductor: solid full copper, AWG 24
• Connector: RJ45 with snagless boot
• Contact plating: 50 µin gold
• Maximum supported data rate: 10 Gbps
• Warranty: 5 years

How to use

Plug one RJ45 connector into the network port of your device and the other end into a switch, router or patch panel. Ensure connectors are fully inserted until the latch engages. Route the cable to avoid tight bends and sharp edges and maintain separation from high-voltage power cables to minimise interference.

Recommendations

For best performance, use the cable within standard CAT6A installation practices: avoid bends smaller than the cable diameter, keep termination points secure, and replace the cable if the connector or conductor shows visible damage.